HPlogo System Startup, Configuration, and Shutdown Reference Manual > Appendix A Using the Access Port (AP)

Appendix A Using the Access Port (AP)

MPE documents

Complete PDF
Table of Contents
Glossary
Index

E0802 Edition 7 ♥
E0201 Edition 6
E0796 Edition 5

Table of Contents
Configuring the Console
Entering Control Mode and Using the Command Interpreter
Interpreting the System Status Line
Using Access Port Commands
Using the AP Help Facility
Returning from Control Mode to Console Mode
Configuring the Access Port
Enabling Remote Console Access
Sending Messages to Both Consoles
Disabling Remote Console Access
Disconnecting the Remote Line
Connecting the Remote Support Modem to a Session Port
Enabling the SPU Hex Status Display
Disabling the SPU Hex Status Display
Hard Resetting the SPU
Transferring Control (Soft Reset)
Testing the AP
Using Control Commands
Interpreting AP Error and Informational Messages
This section describes the access port (AP) commands and provides the procedures for enabling a remote console, for configuring a system remote support modem port, and for performing the AP self-test.



Including Shutdown Information in the Welcome Message

Configuring the Console