This chapter describes how to configure additional
optional configuration parameters that are available from the DTC
Configuration screen. These screens (except for Tune DTC) are only
available from a host-based configuration. These additional screens
allow you to configure the following:
Configure the DTC to use the address
resolution facilities of Domain Name Services (DNS) and IP routing.
These services are only used by Switched DTC ports when connecting
to an ARPA (TCP/IP) node.
Tune your DTC by selecting AFCP, TCP and management
timers that are appropriate for your DTC and network traffic.
Configure the parameters that define how the DTC
user interface behaves on switched DTC ports.
Configure the DTC to act as an SNMP (Simple Network
Management Protocol) agent.
If the configuration is PC-based then refer to the Using
HP OpenView DTC Manager manual.
These additional screens are accessed from the DTC Configuration
screen. When the DTC Configuration screen is accessed, function
key [F5], the [Next Key Labels]
is available. When the [Next Key Labels]
key is pressed, another set of key labels is displayed that allows
these additional screens to be accessed. When the [Next Key Labels]
is pressed again, the original set of function keys is displayed.