Chapter 4 APPC Subsystem Configuration

Table of Contents

Data Required From the Remote Configuration

This chapter describes how to use the NM configuration manager (NMMGR) to create or modify a configuration for the APPC subsystem.

Appendix C “Configuration Worksheets” provides configuration worksheets to help you plan APPC subsystem configuration. Step-by-step instructions for completing the worksheets are included in Appendix C “Configuration Worksheets”




	NOTE: Before you can configure the APPC subsystem, you must have successfully configured SNA/SDLC Link/XL or SNA/X.25 Link/XL (including logging). Configuration of the SNA link products is described in the SNA Link/XL Node Manager's Guide. You must also coordinate the APPC subsystem configuration with the remote system configuration. The HP SNA Products: ACF/VTAM and ACF/NCP Guide, the HP SNA Products: CICS Guide, and the HP SNA Products: AS/400 Guide contain Hewlett-Packard's recommendations for configuring the remote system.

This chapter contains the following sections:




	NOTE: This chapter does not cover logging configuration for the APPC subsystem. Logging configuration is covered in the SNA Link/XL Node Manager's Guide.

Technical documentation