HPlogo HP e3000/iX Network Planning and Configuration Guide > Chapter 8 Configuring a X.25 Node

Chapter 8 Configuring a X.25 Node

MPE documents

Complete PDF
Table of Contents
Index

Table of Contents
Configure an X.25 Network Interface
Configure X.25 Virtual Circuits
Configure Neighbor Gateways
Identify Neighbor Gateways (If Any Are Present)
Identify Neighbor Gateway Reachable Networks
This chapter provides step-by-step instructions for configuring X.25 iX System Access for systems using PC-based network management. This manual assumes that you are using the guided configuration capabilities of NMMGR.

Figure 8-1 "X.25 Link Screen Flow" shows the screen flow for configuring X.25 screens. Screens unique to X.25 configuration are indicated by bold boxed screens. [FUNCTION] denotes the function key used at a screen to invoke the next screen on the screen flow.

Figure 8-1 X.25 Link Screen Flow

[X.25 Link Screen Flow]

Before using NMMGR to configure a link, you should complete the worksheets provided. See Chapter 4 "Planning for Node Configuration" for more information on planning your configuration and filling out the configuration worksheets.

This chapter includes step-by-step instructions to help you perform the following tasks:

  • Begin the configuration process.

  • Configure an X.25 network interface.

  • Configure neighbor gateways.

Once the above tasks are completed, refer to Chapter 10 "Validating and Cross-Validating with SYSGEN" for step-by-step instructions to help you perform the following validation tasks:

  • Validate the network transport configuration.

  • Cross-validate in SYSGEN.

NOTE: If you are configuring X.25 iX System Access on a system that is using host-based network management (a PC running the HP OpenView Network Manager is not part of the network), use Configuring and Managing Host-Based X.25 Links instead of this manual for step-by-step configuration instructions.



Configure Node Mapping

Configure an X.25 Network Interface