SETDUMP
MPE documents | |
 Complete PDF | |
| Table of Contents | |
| Index | |
| Edition 7 E0701 ♥ | |
| Edition 7 E0300 | |
| Edition 6 E0195 |
Syntax
I16V
SETDUMP (flags);
Parameters
- flags
16-bit unsigned integer (required)
This parameter is for backward compatibility with MPE V/E systems only. Any value passed in this parameter is ignored, but a full stack trace is always generated.
Operation Notes
If the process aborts, Debug is called with a command string that results in a full stack trace of the CM and NM data stacks and a dump of the NM registers. This output is sent to the standard list device. If the process that aborts is being run from a job, the process terminates after the stack trace and register dump are performed. If the process is being run from a session, after the stack trace and register dump have completed, Debug stops to accept interactive commands with I/O performed at the user terminal, provided the following conditions are met:
The abort did not occur while in system code.
The process entered the abort code through a native mode interrupt (typically caused by arithmetic and code-related traps).
Condition Codes
| CCE (2) | Request granted. |
| CCG (0) | Request denied. The abort stack analysis facility was already enabled before the SETDUMP call. |
| CCL (1) | Not returned. |
Related Information
| Intrinsics | DEBUG, HPDEBUG, HPRESETDUMP, HPSETDUMP, RESETDUMP, STACKDUMP |
| Commands | DEBUG, RESETDUMP, SETDUMP |
| Manuals |
MPE/iX System Debug Reference Manual MPE/iX Commands Reference Manual |
|
SENDMAIL |
SETJCW |