SETJCW
MPE documents | |
 Complete PDF | |
| Table of Contents | |
| Index | |
| Edition 7 E0701 ♥ | |
| Edition 7 E0300 | |
| Edition 6 E0195 |
Syntax
U16V
SETJCW (jcword);
Parameters
- jcword
16-bit unsigned integer by value (required)
The user-defined bit contents of the system JCW for interprocess communication.
Bits Value/Meaning> 0:1 Reserved for the operating system If (0:1)=1, the system outputs the following message when the program terminates, either normally or due to an error: PROGRAM TERMINATED IN ERROR STATE (CIERR 976)
In batch mode, the job is terminated unless the CONTINUE command is used. If JCW is set to exactly %140000 (bits (0:1)=1 and (1:1)=1 only), the CIERR 976 message is replaced by:PROGRAM ABORTED PER USER REQUEST (CIERR 989)
1:15 Used for any purpose.
Related Information
| Intrinsics | FINDJCW, GETJCW, PUTJCW, HPCIDELETEVAR, HPCIGETVAR, HPCIPUTVAR |
| Commands | DELETEVAR, SETJCW, SETVAR, SHOWJCW, SHOWVAR |
| Manuals |
Interprocess Communication Programmer's Guide Command Interpreter Access and Variables Programmer's Guide MPE/iX Commands Reference Manual |
|
SETDUMP |
SORTEND |