|
|
Table of Contents
- NS 3000/iX LAP-B Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- RESET Parameter Fields
- ALL Parameter Fields
- NS 3000/iX LAN Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- NS 3000/iX IEEE 802.5/Token Ring Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- NS 3000/iX FDDI Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- ALL Parameter Fields
- DIAGNOSTIC Parameter Fields
- Flag Status
- NS 3000/iX 100VG-AnyLAN Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- NS 3000/iX 100Base-T Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- NS 3000/iX LAPBMUX Link Statistics
- LINKSTATE Parameter Fields
- CONFIGURATION Parameter Fields
- STATISTICS Parameter Fields
- RESET Parameter Fields
- ALL Parameter Fields
This appendix defines the fields output by the LINKCONTROL STATUS
command and its associated parameters. The LINKCONTROL STATUS command
enables you to obtain link configuration and statistical data which you can use
for monitoring and debugging the link. This command has several parameters,
each of which provides different configuration or statistical data. The
parameters described in this appendix are as follows:
LINKSTATE
CONFIGURATION
STATISTICS
ALL
RESET
The STATUS=DIAGSTAT command returns information intended for HP
diagnostic use. Its output is not explained in this manual. After issuing this
command you should send the output to your HP representative.
The LINKCONTROL command displays specific information relating to the
type of link that is monitored. The LINKCONTROL command can be used to
obtain information about the following types of NS 3000/iX links:
NS 3000/iX LAP-B links
NS 3000/iX IEEE 802.3 or LAN links
NS 3000/iX IEEE 802.5/Token Ring links
NS 3000/iX Fiber Distributed Data Interface (FDDI) links
NS 3000/iX 100VG-AnyLAN links
NS 3000/iX 100Base-T links
NS 3000/iX LAPBMUX links
The LINKCONTROL command does not work on an X.25 link because the card
is located in the DTC. For equivalent functionality, use the OpenView DTC
manager.
|