Chapter 1 Installation Procedure

Table of Contents

1. Prepare to Install the Adapter

Observe Antistatic Precautions

Verify Product Contents

Record Adapter Information

Gather Tools and Accessories

2. Shut Down the Operating System and Switch Off the Computer

3. Install the Adapter

a. Access the adapter slot(s)

b. Select an available slot

c. Insert the adapter into the slot

d. Switch on the power to the computer.

4. Attach the Adapter to the Network

5. Configure the Adapter into the System

6. Verify Operation

This section contains installation instructions for the HP-PB 100VG-AnyLAN Network Adapter. The instructions are organized into six primary steps listed below. Each step is described in detail in this section. If the adapter has already been installed at the factory, you may proceed directly to step 4.

1. Prepare to install the adapter.

2. Shut down the operating system and switch off the computer.

3. Install the adapter.

4. Attach the adapter to the network.

5. Configure the adapter into the system.

6. Verify operation.