You can display information about the location configuration
file or network directory file using the CONFIGURATION SUMMARY
available as part of NETTOOL.
You can also use this tool to compare one configuration file to
another.
You can access information about configured network names
and addresses using the NAME-ADDRESS MANAGER
which is also available through NETTOOL.
To Display Local Configuration |
 |
Perform the following steps to display a summary of the local
system's configuration:
Run the NETTOOL
utility by entering the program name:
NETTOOL.NET.SYS
The root menu will appear.
Enter CONFIG
to run the CONFIGURATION SUMMARY
tool. The CONFIG
menu will appear.
Enter SUMMARY
to display a summary of the network transport and logging configuration
values. (Note that logging values may not be recorded for some MPE/iX
releases.)
To Display Link Configuration Information |
|
You can display the configuration values for a specific link
(excluding X.25 links) by using the LINKCONTROL STATUS
command. (You can also use the STATUS NETTOOL.)
To display configuration values for
a link on the local node called SYSLINK,
enter the following command at the MPE prompt:
LINKCONTROL SYSLINK;STATUS=Configuration
See Chapter 7 “Commands ” for
more information on using LINKCONTROL.
See Appendix A “LINKCONTROL Command” for information
on the LINKCONTROL status
displays.
To Display Network Directory Configuration |
|
Perform the following steps to display a summary of the local
system's network directory configuration:
Run the NETTOOL
utility by entering the program name:
NETTOOL.NET.SYS
The root menu will appear.
Enter CONFIG
to run the CONFIGURATION SUMMARY
tool. The CONFIG
menu will appear.
Enter NETDIR
to display a summary of the network directory configuration.
