This appendix defines the fields output by the LINKCONTROL STATUS
command and its associated parameters. The LINKCONTROL STATUS
command enables you to obtain link configuration and statistical
data which you can use for monitoring and debugging the link. This
command has several parameters, each of which provides different
configuration or statistical data. The parameters described in this
appendix are as follows:
The STATUS=DIAGSTAT command returns information
intended for HP diagnostic use. Its output is not explained in this
manual. After issuing this command you should send the output to
your HP representative.
The LINKCONTROL command displays specific
information relating to the type of link that is monitored. The
LINKCONTROL command can be used to obtain information
about the following types of NS 3000/iX links:
NS 3000/iX IEEE 802.3/Ethernet (LAN) links
NS 3000/iX Token Ring links
NS 3000/iX Fiber Distributed Data Interface
(FDDI) links
NS 3000/iX 100VG-AnyLAN links
NS 3000/iX 100Base-T links
The LINKCONTROL command does not work on
an X.25 link because the card is located in the DTC. For equivalent
functionality, use the OpenView DTC manager.