The X.25 PVC Address Key Paths screen (#163) in Figure 7-9 “X.25 PVC Address Key Paths Screen” is displayed when you
press the [Go To PVCPATH] function key at the General
X.25 Configuration screen (Figure 7-5 “General X.25 Protocol Screen”).
It is also displayed when you type the path name:
@NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH
in the Command window of any screen and press the [Enter]
key, where NIname is a configured X.25 NI.
Figure 7-9 X.25 PVC Address Key Paths Screen
You may configure up to 128 PVC address keys under
an X.25 NI, and if configuring multiple X.25 NI's, no address key
can be used more than once per system.
Fields
- X.25 address key
The X.25 address key is used to identify a remote
node to which this node will communicate. The address key can have
up to eight alphanumeric characters, the first of which must be
alphabetic.
Default: None.
- PVC number
The PVC number is a permanent virtual circuit number
which identifies the remote host for the node you are configuring.
This number must be in the PVC range you defined in the OpenView
DTC Manager configuration. This is a required field if you defined
a corresponding X.25 address key.
Default: None