The Security String(s) Configuration screen (#110) supplies
the security string required by the Dial ID protocol for the node
you are configuring. (Note that the security string is not required
if dial ID protocol is not enabled.) This screen, shown in Figure 6-7 “Security String(s) Configuation Screen”, is displayed if you pressed
the [Go To Security] function key at the preceding
Dial ID Protocol Configuration screen (Figure 6-6 “Dial ID Protocol Configuration Screen”). It is also displayed when you type the
path name:
@NETXPORT.NI.NIname.PROTOCOL.DIAL.SECURITY
in the Command window of any screen and press the [Enter]
key, where NIname is a configured point-to-point
NI.
Figure 6-7 Security String(s) Configuation Screen
![[Security String(s) Configuation Screen]](img/gfx37.gif)
Press the [Save Data] function key to transfer
the data displayed on the screen to the configuration file you are
creating or updating. You verify that the data record has been created
by checking that the Data flag is set to Y.
Fields
- Configured security strings
Enter the security string that the remote nodes
must use to gain dial link access to the node you are configuring.
The string can contain up to eight alphanumeric characters, left
justified, with no embedded blanks. To delete a security string,
blank out the field that contains the string you want deleted, then
press the [Save Data] function key.
Default value: HP
Related screen:
NETXPORT.NI.NIname.LINK.linkname
The dial IP protocol is enabled or disabled on this screen.
