This section contains information about the NMMGR
configuration screens that are common to all network interfaces.
The network transport configuration branch of NMMGR begins with
a screen called the Network Transport Configuration Selection screen.
Figure 4-1 “Network Transport configuration Screen
Flow” shows the screen flow
for configuring the Network Transport Configuration screens. Screens
unique to the Network Transport Configuration are indicated by bold
boxed screens. [FUNCTION] denotes the function
key used at a screen to invoke the next screen on the screen flow
Figure 4-1 Network Transport configuration Screen
Flow
![[Network Transport configuration Screen Flow]](img/gfx14.gif)
The Network Transport Configuration Selection screen allows
you to define global parameters for the node as well as network
interfaces of type LAN, ROUTER (point-to-point), X.25, SNA, TOKEN
(token ring), FDDI, 100VG-AnyLAN, 100Base-T, Gateway Half, or Loopback.
To reach the network transport configuration screens, run
NMMGR, and refer to the following pages of this section for a step-by-step
process.
Step-by-Step Process:
Run NMMGR. The Open Configuration/Directry
File screen is displayed.
Enter the configuration file name (NMCONFIG.PUB.SYS)
and password, if a password is required, and press the [Open Config]
function key. If you have not yet created the configuration file
you will need to press the key a second time. The Main screen is
displayed.
Press the [NS] function key. The NS
Configuration screen is displayed.
Press the [Unguided Config] function
key. The Unguided Configuration screen is displayed.
Press the [Go To NETXPORT] function
key and the Network Transport Configuration Selection screen is
displayed.
For more general information on NMMGR, refer to Using
the Node Management Services (NMS) Utilities.
 |
| |
|
 | NOTE: Fields described as "HP modifiable"
should be changed only upon the recommendation of your Hewlett-Packard
representative. |
|
| |
|
