Cross-validation ensures that there are no conflicts in the
use of node names, device classes, and physical paths between the
data currently contained in NMCONFIG.PUB.SYS
and the system configuration data. To cross-validate, use the SYSGEN
facility (OP capability is required). To use SYSGEN, type the following
commands at the MPE prompt (user input is bold):
- sysgen
sysgen> io
io> ld (optional)
io> exit
sysgen> exit
The optional ld (list devices) command
allows you to verify the NMMGR devices that are configured.
Cross-validation is done on the KEEP, TAPE,
I/O, and RDCC commands in
SYSGEN. For more information, see System Startup, Configuration,
and Shutdown.
If you have completed the configuration process, proceed to
Chapter 14 “Operating the Network”