This command is valid from the remote support modem port only.
Entering SE causes the remote support modem port to connect through to a session port. If DTR is on, the remote support port's modem remains connected. The remote support modem is able to initiate a session using a normal connection protocol, as if a new modem connection had just been established. To reenter control mode, the remote support port modem must drop the connection and redial.
Using this command and the port operation, a user at the Response Center is able to use control, console, and session mode without any intervention by the local operator. (The operator must enable remote capability of the system.)
The following message is generated if the local console operator tries to execute the SE command:
Command may not be executed by local user. (APERR 15)
|
