The command ER enables remote access to control and console modes through the remote support modem port. The command is only valid from the system console. ER allows you to set the remote access password, the number of password tries, and single or multiple access.
Using the ER command generates the following prompts:
CM>ER Return
Current remote console access configuration:
Mode: Multiple
Password: The quick brown fox
Password faults: 10
Do you wish to change the configuration? (Y/N): Y Return
Enter your changes. <CR> retains the current value.
Current mode: Multiple
Select the new setting (S=single, M=multiple): Return
Current password: The quick brown fox
New password (1 to 24 displayable characters or space
if no password is to be required): Return
Current password fault limit: 10
New number of password faults (Range: 0-99 or space.
Space or 0 will permit unlimited password faults.): 5 Return
New remote console access configuration:
Mode: Multiple
Password: The quick brown fox
Password faults: 5
Remote console access is now enabled.
CM>
|
The new access status settings do not take effect until you finally answer the change query with NO.
If, during the process of updating the access status settings, the AP encounters any unexpected or inappropriate input, it may respond with a combination of the following messages:
Expecting "Y" or "N" (APERR 11)
Expecting "S" or "M" (APERR 16)
String was truncated to 24 characters. (APMSG 04)
Your selection is outside of the legal range. (APERR 14)
Command may not be executed by a remote user. (APERR 13)
|
Upon NVM failure, the following default values are used: remote disabled, multiple access mode, maximum fault limit = 3, no password required.