Configuring the Console

Some of the terminal configuration parameters are important for proper AP operation. Both terminals connected to ports T0 (system console) and T1 (remote support modem port) should be configured with the following parameter settings:

From the DATACOMM CONFIGURATION menu:

   Parity/DataBits  None/8

   Chk Parity  NO

   EnqAck  YES

   CS(CB)Xmit  NO

   RecvPace  Xon/Xoff

   XmitPace  NONE

From the TERMINAL CONFIGURATION menu:

   LocalEcho  OFF

   SPOW(B)  NO

   Line/Page(D)  LINE  (**necessary during control mode**)

   ReturnDef  Return

Parameters not mentioned can be set to any value and do not affect AP operation.

	NOTE: The AP is designed to operate with the HP 700/92 terminal. There have been no deliberate steps taken to preclude operation with other terminals (for example, the AP does not check the terminal identification and refuse to operate with anything else), but no other terminals have been tested for proper operation. Use other terminals at your own risk.