|
|
System Debug Reference Manual: HP 3000 MPE/iX Computer Systems > Appendix C Emulated/Translated CM CodeNM Breakpoints in Translated Code |
|
The following discussion assumes that the current Debug mode is NM (prompt is: $nmdebug > ). NM breakpoints can be set at every instruction within translated code even if the instruction is not at a node point. This allows careful inspection of the actual sections of NM translated code.
For example, the following commands set two breakpoints. The first is at a node point, and the second is not at a node point:
The single step command (S) can be used to step through individual NM Instructions within translated code. |
|