This section describes the HP 3000 operating environment that supports
LU 6.2 API/XL.
Hardware |
 |
The following hardware is required to run LU 6.2 API/XL:
An HP 30263A Programmable Serial Interface (PSI)
card and the appropriate PSI cables. The PSI is bundled with SNA/SDLC Link/XL
or SNA/X.25 Link/XL. One PSI is required for each link to a remote
system.
A full or half duplex data communication line (switched
or leased) between the HP 3000 and the remote system.
A pair of modems for the communication line. Only
full-duplex, synchronous modems are supported.
A block-mode terminal which is supported by VPLUS/3000
for Node Management Services configuration.
Software |
|
The following software is required to run LU 6.2 API/XL on
the HP 3000:
LU 6.2 API/XL, version B.00.00 or
later.
The HP 3000 Multi-Programming Executive (MPE XL)
operating system (release 4.0 or later).
SNA/SDLC Link/XL or SNA/X.25 Link/XL bundled hardware
and software product, version B.00.10 or later.
Node Management Services (NMS) version B.03.00 or
later.
