 |
» |
|
|
|
Before you install LU 6.2 API/XL on the HP 3000 you must do
the following: Ensure that the remote system has all
the required hardware and software listed under "Remote
System Requirements," later in this appendix. Ensure that the modem link operates between the
HP 3000 and the remote system. If you use HP modems, Hewlett-Packard
will help you verify that these modems work. Configure a remote PU and terminal to the remote
system using Hewlett-Packard's recommended parameters. You may have
to make system generation changes to ACF/NCP, ACF/VTAM, and application
subsystems running under ACF/VTAM. To connect to an AS/400, you
may have to modify the AS/400 configuration. For more information
on host configuration, consult the following manuals: | HP
SNA Products: Manager's Guide
HP
SNA Products: ACF/VTAM and ACF/NCP Guide
HP SNA Products:
CICS Guide
HP SNA Products: AS/400 Guide |
Obtain a copy of the remote system configuration. You will
need this information later during LU 6.2 API configuration. Ensure that SNA/SDLC Link/XL or SNA/X.25 Link/XL
has been installed correctly. Ensure that your HP 3000 is at the proper release
level to run LU 6.2 API/XL.
|
