|
|
HP 3000 MPE/iX Release 6.0 System Software Maintenance Manual (Release C.60.00): HP 3000 MPE/iX Computer Systems > Chapter 3 Planning for Your Task3.5 Checking Peripherals |
|
Proceed to the subsection for your device:
Then review the following subsections:
To update or add-on to your system software using a CD-ROM, you must have a CD-ROM drive installed and configured. Refer to Appendix E “CD-ROM Resources” Verify that the CD-ROM drive you are using is one of the following:
An Upgrade Kit (C2293U) for the Series 6000 peripheral package allows you to use internal SCSI drives on some HP 3000 computer systems. If you do not have one of these compatible drives, contact your HP representative to order one. If you have a compatible CD-ROM disk drive, proceed to the subsection, "LDEV 1 Disk Minimum Capacity." If you are already on version 5.0 or 5.5 of the system software, skip this section and proceed to "LDEV 1 Disk Minimum Capacity." If your system software version is earlier than 5.0, and you have a SCSI-DDS tape device, do the following as part of the update to 5.0 or 5.5 before this update to 6.0:
If you run AUTOINST from one of the listed devices with an incompatible firmware revision, AUTOINST will fail. The spoolfile output from the restore will include this message:
LDEV 1 requires a minimum capacity of 500 MBytes. As of Release 5.0, you cannot use the older HP7933 or HP7935 disk drives as LDEV 1 (the system disk). When you update to MPE/iX Release 6.0, you may still use HP7933 and HP7935 drives elsewhere on your system, but these drives do not have a large enough capacity to serve as the system disk. To identify your LDEV 1 device, use the DSTAT ALL command to determine the logical device numbers of configured devices.
If you have a CIO system and you are using a disk drive with over 2 GBytes capacity as your LDEV 1, any disk space over the 2 GBytes is not available for use. It cannot and will not be used for system or user files. If you have an NIO system and you are using a disk drive with over 4 GBytes capacity as LDEV 1, any disk space over the 4 GBytes is not available for use. It cannot and will not be used for system or user files. The 9 GB disk drive cannot be used as LDEV 1. The predefined variable HPCPUNAME contains the name of your computer model.
This is a sample reply:
See Table 3-4 “NIO/CIO Systems” for a list of NIO/CIO systems. Table 3-4 NIO/CIO Systems
|
|