HP 3000 Manuals

DCE for the HP 3000

Chapter 3  Configuring DCE Cells 

This section provides general information on using the DCE configurator
to add your MPE/iX HP 3000 system into a cell.  It is divided into two
subsections:

   *   Using the DCE Configuration Tool - provides detailed steps to
       bring up the DCE Configuration main menu (these steps must be
       completed each time you change the DCE cell configuration).

   *   Using the DCE Configuration Options - provides detailed steps for
       each option in the DCE configuration main menu (basic familiarity
       with DCE terms and concepts are assumed, as described in the
       Introduction to OSF DCE (B3190-90005).


NOTE  To configure a cell, you must have previously completed the
      installation procedure (refer to Chapter 2, "Installing DCE/3000
      Software", for planning and installation information).

MPE/iX 5.0 Express III Documentation