HP 3000 Manuals HP 3000 Manuals
Installation
To install DCE/3000, perform the following steps:
1. Log off all users and log on at the console as MANAGER.SYS.
2. Create the following groups if they do not exist. At the system
prompt, enter:
NEWGROUP HPDCE.SYS
NEWGROUP THREADS.SYS
NEWGROUP B3821A.SUPPORT
for product B3821AA
or
NEWGROUP B3822A.SUPPORT for product B3822AA
3. Restore the files from your DCE product tape.
_________________________________________________________________
NOTE Do not use the local option in the RESTORE command. If the
local option is used, the DCE files will not be restored
correctly.
_________________________________________________________________
At the system prompt, enter:
FILE TAPE;DEV=TAPE
RESTORE *TAPE;@.@.@;SHOW
4. Start the product installation job by entering the following:
STREAM I00B3821.B3821A.SUPPORT for product B3821AA
or
STREAM I00B3822.B3822A.SUPPORT for product B3822AA
5. If the message "DCE has been successfully installed" is displayed
at the console, the DCE installation has completed successfully.
If the message is not displayed or if a warning message(s) is
display at the console, the DCE software has probably not
completed its installation. Check the spoolfile to find out why
it will not complete.
_________________________________________________________________
NOTE If you currently have DCE configured but stopped, then the
/etc/rc.dce file contains the current configuration. The
installation job (IOUB3821 or IOUB3822) will not write over
this file, instaed it renames the new /etc/rc.dce file to
/etc/rc.dce.102. It is strongley recommended that you
compare your /etc/rc.dce file with the /etc/rc.dce102 file
and make any necessary changes.
_________________________________________________________________
6. Ensure that the network services are brought up with the
appropriate interface name.
You must install the DCE software on all of the HP 3000 systems that you
plan to configure in your cell. After all of the systems have DCE/3000
installed, you can configure your cell.
Refer to Chapter 3, "Configuring DCE Cells," for cell configuration
information.