HP 3000 Manuals

HP Predictive Support CE Guide For HP 3000 Series 900

Phase 2:  Restarting the DTC 

The DTC must be restarted after the system restart under either of the
following conditions:

   *   The DTC is Host-based and changes to NMMGR have been made.

   *   The DTC is PC-based and changes to OPENVIEW have been made with
       the "Configure" screen.

To restart the DTC, use one of the following methods, as appropriate:

If Host-Based: 

   *   Turn the power off, and then on again (the switch is located on
       the back of the DTC).

OR

   *   Use TERMDSM Reset.

If PC-Based: 

   *   Turn the power off, and then on again (the switch is located on
       the back of the DTC).

OR

   *   Use OPENVIEW Reset.

MPE/iX 5.0 Documentation