HP 3000 Manuals HP 3000 Manuals
Chapter 5 Preparing to Configure X.25 iX System Access
This chapter details the information you will need before you can begin
to configure X.25 iX System Access for host-based systems that will
include an X.25 system-to-system link. Sample worksheets are included to
ease configuration.
Hewlett-Packard recommends that you configure the datacommunications and
terminal subsystem (DTS) before configuring the NS X.25 link. If you
have not already done so, turn to chapters 2 and 3 in this manual for
information on how to configure your system's DTCs.
If you also need to configure a point-to-point link or a LAN link, see
the HP 3000/iX Network Planning and Configuration Guide (36922-61023).
This chapter describes how to:
* Plan the network configuration for X.25 iX System Access.
* Determine network characteristics for X.25 iX System Access.
* Identify Neighbor Gateways.
_________________________________________________________________
NOTE If you are configuring X.25 iX System Access on a system
using PC-based network management (an OpenView workstation
is part of the network), you should use the HP 3000/iX
Network Planning and Configuration Guide instead of this
manual to configure the X.25 link.
_________________________________________________________________