HP 3000 Manuals HP 3000 Manuals
RPGGO
Compiles, prepares, and executes an RPG/V program in compatibility mode.
RPG/V is not part of the 900 Series HP 3000 Computer System Fundamental
Operating Software and must be purchased separately.
Syntax
RPGGO [textfile][,[listfile][,[masterfile][,newfile]]]
Parameters
textfile The actual file designator of the input file from
which source program is read. This can be any
ASCII input file. The formal file designator is
RPGTEXT. Default is $STDIN.
listfile The actual file designator of the file on which the
program listing is written. This can be any ASCII
output file. The formal file designator is
RPGLIST. Default is $STDLIST.
masterfile The actual file designator of a file which is
merged against textfile to produce a composite
source. This can be any ASCII input file. The
formal file designator is RPGMAST. Default is that
the master file is not read; input is read from
textfile, or from $STDIN, if textfile is not
specified. If two files being merged have
identical line numbers, the lines from textfile or
from $STDIN overwrite those in masterfile.
newfile The actual file designator for the file produced by
merging the textfile and the masterfile. This can
be any ASCII output file. The formal file
designator is RPGNEW. Default is that no file is
written.
NOTE The formal file designators used in this command (RPGTEXT, RPGLIST,
RPGMAST, and RPGNEW) cannot be backreferenced as actual file
designators in the command parameter list. For further
information, refer to the "Implicit FILE Commands for Subsystems"
discussion of the FILE command.
Operation Notes
This command compiles, prepares, and executes an RPG program. If you do
not specify textfile, MPE/iX expects the source code to be entered from
your standard input device.
The USL file created during compilation is a system-defined temporary
file $OLDPASS, which is passed directly to the MPE segmenter. It cannot
be accessed, since the segmenter also uses $OLDPASS to store the prepared
program segments and overwrites the USL file of the same name.
Use
This command may be issued from a session, job, or program. It may not
be issued in BREAK. Pressing Break suspends the execution of this
command. Entering the RESUME command continues the execution.
Examples
To compile, prepare, and execute an RPG program entered from your
standard input device and send the program listing to your standard list
device, enter:
RPGGO
To compile, prepare, and execute an RPG program read from the disk file
SOURCE and send the program listing to the disk file LISTFL, enter:
RPGGO SOURCE,LISTFL
Related Information
Commands RPG, RPGPREP, PREP, RUN
Manuals MPE Segmenter Reference Manual (32650-60026)
RPG/3000 Compiler Reference Manual (32104-90001)