HP 3000 Manuals

Running the SDCONV Program [ HP System Dictionary XL Gen. Ref. Vol. 2-Part 3 SDCONV ] MPE/iX 5.0 Documentation

HP System Dictionary XL Gen. Ref. Vol. 2-Part 3 SDCONV

Chapter 2  Running the SDCONV Program 

Running the Program 

Enter the following command to run the conversion utility:

     RUN SDCONV.PUB.SYS 

No file equations are required.  However, if you wish to redirect input
and/or report output, you may use the file equations provided by the
program.

When the program is successfully loaded, it issues the following banner

     System Dictionary SDCONV HP32254v.uu.ff - (c) Hewlett Packard Co. 1985

You can start entering commands at the '>' prompt.

MPE/iX 5.0 Documentation