HP 3000 Manuals

HP System Dictionary XL Intrinsics

SDDeleteEntScope 

Deletes a scope's access to an entity.

Syntax 

     SDDeleteEntScope (Dcb,EntityType,Entity,Scope,Status)

Parameters 

Dcb                       Required input; type = DcbType 
                          This parameter passes information about the
                          dictionary to this intrinsic.  It is
                          initialized by the SDOpen intrinsic.

EntityType                Required input; type = NameOrNumberType 
                          This parameter specifies the entity type of the
                          entity whose association with a scope is to be
                          deleted.

Entity                    Required input; type = NameOrNumberType 
                          This parameter specifies the entity whose
                          association with a scope is to be deleted.

Scope                     Required input; type = NameOrNumberType 
                          This parameter specifies the scope whose
                          association with the entity is to be deleted.

Status                    Output; type = StatusType 
                          This parameter contains information indicating
                          the success or failure of the intrinsic call.
                          This information is detailed in Table 3-1,
                          located in Chapter 3 of this manual.

Discussion 

The following restrictions apply when using this intrinsic:

   1.  Open mode--The dictionary must be opened in either Shared Update 
       mode or Exclusive Update mode.

   2.  Security--The current scope must be either the Dictionary
       Administrator scope, the entity's owner scope, or the scope whose
       association with the entity is to be deleted.

MPE/iX 5.0 Documentation