HP 3000 Manuals

HP System Dictionary XL Intrinsics

SDDeleteDomainScope 

Deletes a scope's access to a domain.

Syntax 

     SDDeleteDomainScope (Dcb,Domain,Scope,Status)

Parameters 

Dcb                       Required input; type = DcbType 
                          This parameter passes information about the
                          dictionary to this intrinsic.  It is
                          initialized by the SDOpen intrinsic.

Domain                    Required input; type = NameOrNumberType 
                          This parameter specifies the domain whose
                          association with Scope is to be deleted.

Scope                     Required input; type = NameOrNumberType 
                          This parameter specifies the scope that is
                          associated with the domain.

Status                    Output; type = StatusType 
                          This parameter contains information indicating
                          the success or failure of the intrinsic call.
                          This information is detailed in Table 3-1,
                          located in Chapter 3 of this manual.

Discussion 

The following restrictions apply when using this intrinsic:

   1.  Open mode--The dictionary must be opened in either Shared Update 
       mode or Exclusive Update mode.

   2.  Security--The current scope must be either the Dictionary
       Administrator scope, the domain's owner scope, or the scope from
       which the association is to be deleted.

MPE/iX 5.0 Documentation