HP 3000 Manuals

Using the Node Management Services (NMS) Utilities

To Run NMDUMP 

   1.  Type

       :RUN NMDUMP.PUB.SYS

   2.  Enter either (1) logging or (2) tracing.

   3.  Enter the ID number for each subsystem you want to format.  Use a
       comma to separate each number.  (Default = ALL.)

   4.  Change the default (NO) to (YES) if you would like to enter
       subsystem options.  (NMDUMP will set the default options if (NO)
       is entered.)

          a.  Enter the subsystem ID for the options you want to change.

              Enter the number of the option or <CR> to select the
              current options.

   5.  Enter the input log or trace file name.  (Must already exist on
       the system.)

       FILENAME.GROUP.ACCOUNT

   6.  Enter the output log or trace file name.  Default = $STDLIST.
       (Must not yet exist on the system.)

       FILENAME.GROUP.ACCOUNT

   7.  Change the default (NO) to (YES) if you want to specify a time
       range.

          a.  Enter the starting time.

              Respond Y or N if the displayed time is correct.

          b.  Enter the finishing time.

              Respond Y or N if the displayed time is correct.

   8.  Press [CTRL]Y when you have completed your responses.  (NMDUMP
       will then give you a chance to re-enter the values)

   9.  Use the default (NO) if you are satisfied with your entered
       values.  NMDUMP then formats the logging or tracing information
       you specified.

MPE/iX 5.0 Documentation