HP 3000 Manuals

Configuring Systems for Terminals, Printers, and Other Serial Devices

Copy the Sample File 

Network information is stored in a configuration file called
NMCONFIG.PUB.SYS. If you do not already have a NMCONFIG.PUB.SYS file,
create a copy of NMCONFIG.PUB.SYS from the sample configuration file
supplied on the HP 3000, NMSAMP1.PUB.SYS.

To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these commands at
the MPE/iXprompt (:):

                                 Table 6-1.   

-----------------------------------------------------
|  |                                                |
|  | HELLO MANAGER.SYS,PUB                          |
|  |                                                |
-----------------------------------------------------
|  |                                                |
|  | FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1             |
|  |                                                |
-----------------------------------------------------
|  |                                                |
|  | FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW      |
|  |                                                |
-----------------------------------------------------


NOTE  "DEV=1" must be specified in the FILE equation to specify that the
      NMCONFIG.PUB.SYS file is to be stored to system disk 1.



CAUTION  If ANY other configuration file is copied to NMCONFIG.PUB.SYS
         NMCONFIX.PUB.SYS then dynamic configuration will be disabled
         until a DTS shutdown and restart is done or the system is
         rebooted.  This includes other files from the same system or
         files copied from other systems.

MPE/iX 5.5 Documentation