HP 3000 Manuals HP 3000 Manuals
OpenView DTC Manager and NMMGR
When the system is configured for PC-Based management, there are several
parameters configured in NMMGR that must match corresponding parameters
configured in the OpenView DTC Manager. For each DTC that is to have
access to the system using nailed devices there must be a corresponding
DTC configured on the OpenView DTC Manager. The corresponding DTC is the
DTC that has the same DTC Node Name in NMMGR and the OpenView DTC
Manager. The following is a list of those parameters that must match and
the step where the parameter is configured in NMMGR:
* The HP 3000's node name configured in step 3 must match the
default destination for any DTC ports configured as non-switched
terminals or DTC ports configured as dedicated printers.
* The DTC's node name configured in step 6 must be configured for a
corresponding DTC on the OpenView DTC Manager.
* The DTC's card types and configuration, configured in steps 6 and
7 must match the configuration of a corresponding DTC on the
OpenView DTC Manager.
* The PAD device name and the PAD device type, if one is specified,
that is configured in step 7, subsection Configure X.25 card, must
match the PAD device name and type configured on the PAD access
screen on the OpenView DTC Manager.