HP 3000 Manuals

Configuring Systems for Terminals, Printers, and Other Serial Devices

Chapter 5  Configuring Serial Devices (for Host-Based Management) 

This chapter provides step-by-step instructions for configuring terminal,
printer, and other serial device connectionson the HP 3000 Series 900
using host-based management (that is, when the DTCs are managed by the HP
3000 host).  For information on configuring for PC-based management,
refer to chapter 6, "Configuring Serial Devices (for PC-Based
Management)." PC-Based Management means that you use an HP OpenView
Workstation (PC) to manage your DTCs.

This chapter will use the configuration information that was collected on
the worksheets in chapter 2, "Before Configuring Terminal and Printer
Connections".


NOTE  If you use OpenView DTC Manager to manage your DTCs, refer to
      chapter 6 instead of this chapter.


This chapter contains configuration information for host-based management
(that is, when the DTCs are managed by the HP 3000 host). 


NOTE  If you are configuring X.25 networking capabilities on a HP 3000
      Series 900 computer using host-based network management, use
      Configuring and Managing Host-Based X.25 Links (36939-61004)
      instead of this manual to configure DTCs and DTC connections.

MPE/iX 5.5 Documentation