HP 3000 Manuals HP 3000 Manuals
DTS Restart The DTS restartcapability is provided by the DTCCNTRLcommand and allows you to restart the DTS subsystem.
NOTE The DTS must first be shutdown before it can be restarted.
Performing a DTS Restart To perform a DTS restart, type the DTCCNTRL command at the CI prompt either without specifying the desired restart operation or by specifying it using the syntax outlined below: * DTS restart operation not specified: Table 4-7. ------------------------------------------------------------------ | | | :DTCCNTRL | | | ------------------------------------------------------------------ | | | | 0 | exit | | | | ------------------------------------------------------------------ | | | | 1 | dynamically implement DTS changes made in NMMGR | | | | ------------------------------------------------------------------ | | | | 2 | view status of last DTS dynamic configuration | | | | ------------------------------------------------------------------ | | | | 3 | automatically add a new DTC | | | | ------------------------------------------------------------------ | | | | 4 | shutdown DTS subsystem | | | | ------------------------------------------------------------------ | | | | 5 | restart DTS subsystem | | | | ------------------------------------------------------------------ | | | | 6 | manage/dynamically configure host-based x.25 | | | | ------------------------------------------------------------------ | | | | 7 | help | | | | ------------------------------------------------------------------ | | | | ------------------------------------------------------------------ | | | For help on these topics, select 7 at the prompt below. | | | ------------------------------------------------------------------ | | | | ------------------------------------------------------------------ | | | Select one of the numbers above corresponding to the | | desired operation: 5 | | | ------------------------------------------------------------------ * DTS restart operation specified: :DTCCNTRL func=restart
NOTE To dynamically configure DTS changes, refer to the "Dynamic Configuration" section earlier in this chapter. To automatically add/configure a host-based managed DTC to DTS without needing to specify detailed configuration information such as DTC cards/boards and ldevs, refer to chapter 3. To manage/dynamically configure host-based X.25 links, refer to Configuring and Managing Host-Based X.25 Links (36939-61004).