HP 3000 Manuals

Configuring Systems for Terminals, Printers, and Other Serial Devices

Chapter 3  Automatic Configuration of DTCs 

This chapter describes how you can add and configure a new host-based
managed DTC to the HP 3000 system without needing to specify detailed
configuration information such as DTC cards/boards and ldevs (herein
referred to as automatic configuration). 

You can perform an automatic configuration by using a command file that
is activated either outside or inside the NMMGR utility.  You may choose
to add a DTC automatically inside NMMGR if you need to make other DTS
configuration changes.  These two methods are described below.


NOTE  If you want to dynamically implement DTS changes made in NMMGR
      (dynamic configuration) or perform a DTS shutdown or restart, refer
      to chapter 4.  If you want to manage/dynamically configure
      host-based X.25 links, refer to Configuring and Managing Host-Based 
      X.25 Links (36939-61004).

MPE/iX 5.5 Documentation