HP 3000 Manuals HP 3000 Manuals
Programmatic Control Messages
The following informational messages may be displayed by RJE when
programmatic control is being used:
For more information about these messages, refer to Chapter 5, "Using RJE
in Programmatic Mode."
---------------------------------------------------------------------------------------
MESSAGE *** SAVED RJOUT IS NEXT ***
The saved #RJOUT command is shown here.
CAUSE This message is issued when RJE is operating in repeat mode
each time the repeating #RJOUT subsystem command is executed.
The saved #RJOUT command follows the informational message.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE ** RJOUT INTERRUPTED: MSG. FILE
CAUSE This message is issued when RJE is operating in interrupt mode
each time the subsystem reads a command file name from the
message file.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE ** NEW COMMAND FILE: command file name
CAUSE This message is issued when RJE is operating in interrupt mode
each time the subsystem begins processing commands from a new
command file.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE *COMMAND FILE END OF FILE*
CAUSE This message is issued when RJE is operating in interrupt mode
each time the subsystem finishes processing the last subsystem
command of a command file.
ACTION No action required.
---------------------------------------------------------------------------------------