HP 3000 Manuals

RJE User/Programmer Reference Manual

#RJIO 

The #RJIO command applies to special situations where a one-line message
is sent and a variable number of lines are received in response.

Syntax 

     #RJIO messagestring 

Comments 

An #RJIO message is equivalent to the following sequence:

     #RJIN
     messagestring 

     #RJEOD
     #RJOUT;WAIT=3

This is also equivalent to #RJIN followed by #RJOUT.

The following two examples are equivalent to the above sequence:

     #RJIO messagestring 

     #messagestring 

The second form (#messagestring) should be used only in interactive mode
and the message must begin with a special character.  The two commands
are equivalent, but the #RJIO may be omitted for convenience.

To send a /*$DA message to an IBM HASP/370 system and to receive the
response, the four formats are equivalent:

     #RJIN
     /*$DA
     #RJOUT;WAIT=3

     #RJIN
     /*$DA
     #RJEOD
     #RJOUT;WAIT=3

     #RJIO /*$DA

     #/*$DA

The /*$DA command is useful for displaying information about active jobs
on the host.  The '/*' characters allow the user to send job entry
commands to a JES2 host.  For more information on these commands, consult
the IBM publication, Operator's Library:  JES2 Commands (SC23-0048).

MPE/iX 5.0 Documentation