HP 3000 Manuals HP 3000 Manuals
#RJINFO
The #RJINFO command initiates a line information display of the
communications line configuration. The information is printed on
$STDLIST as an aid to diagnosing problems.
Syntax
#RJINFO
An example of the display is shown on the next page. This display is for
RJE/XL; the RJE/V display will be different.
***************************************************
*-L-I-N-E---I-N-F-O-R-M-A-T-I-O-N---D-I-S-P-L-A-Y-*
***************************************************
*LINE NUMBER: 13 LINK NAME: RJE29 *
*EMULATION TYPE: 2780 LINE CODE: ASCII *
*STATION TYPE: PRIMARY *
*TRANSMISSION MODE: FULL_DUPLEX *
*CHECKSUM TYPE: VRC/LRC RETRY LIMIT: 7 *
*LEADING SYNCS: 4 *
*BAUD RATE: 4800 *
*RESPONSE TIMEOUT: 3 *
*CONTINUE TIMEOUT: 2 *
*CONNECT TIMEOUT: 60 *
*LOCAL TIMEOUT: 0 *
*LINEBID TIMEOUT: 180 *
*RECEIVE TIMEOUT: 20 *
*LOCAL ID: *
* *
* L= 2 HEX=5141 *
*REMOTE IDS: *
*PHONE NUMBERS: *
*1 L= 8 725-8111 *
*ERRORCODE: RECOVERABLE=0 IRRECOVERABLE=103 *
* *
*STATUS: INFO=1973 SUBSYS-215 *
* *
*ESTAT=0 MOD_DEP=0 *
* *
***************************************************