|
|
To successfully start bootpd, you must have a current and correct
configuration file for it. The default file is /etc/bootptab but you
may use an alternate configuration file by specifying its POSIX file name on
the command line. Without this configuration file, bootpd will not be
able to service BOOTP requests.
You can run bootpd under the Internet daemon only. You may not run
it as a standalone server.
Starting bootpd Under inetd
If you are running bootpd with inetd, make certain that you
have edited the inetd configuration file as explained earlier in this
chapter. There is no special step required of you to start bootpd:
When the Internet daemon is running, it will automatically invoke
bootpd when it gets a connection request for that service. To find out
how to start inetd, refer to Chapter 2 Internet
Daemon
Command Line Options for bootpd
You can change the way that bootpd operates by entering the
bootpd command followed by one of the command line options. For
example:
:BOOTPD.NET.SYS -d
The options available to you are explained below.
- Option
Purpose
- -t
Changes the timeout value for bootpd. The BOOTP
daemon starts when the first BOOTP request arrives. If no other
boot request arrives within the default period of 15 minutes,
bootpd ends. If you specify a timeout of 0 minutes, the server
will not die until you abort JINETD or JINETD ends in
an error state.
- -d
Sets the verbosity level for the logging messages generated by
bootpd.
- configfile
The configuration file bootpd reads to get configuration
information, expressed in HFS syntax. By default, bootpd uses
/etc/bootptab.
|