A common streams_device value is 10. An LP device
must be configured in SYSGEN. Already spooled and
streamed messages might display.
Shutdown the system.
CTRL-A
=SHUTDOWN
Reset the system after the last shutdown message (SHUT6).
If you have an HP e3000 Series 99x, connect to the service
processor before you can restart the system. Type the following:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
Do not respond to the question:
Press any key within 10 seconds to cancel boot with this
configuration.
There are 5 to 10 minutes of system activity, then the Processor
Dependent Code (PDC) screen displays.
For HP e3000 N-Class, A-Class
CTRL-B
Service Processor login:
Service Processor password:
If you get the following prompt, then enter the characters 'Ctrl-E c f'
to gain write access to the GSP.
[Read only - use ^Ecf for console write access.]
GSP>RS
For all other systems, enter the following commands to reset
the system:
CTRL-B
CM>RS
If the system does not respond to the CTRL-B entry within
ten seconds, press the reset button, key switch, or on/off switch
as appropriate for your system. The system will halt, and then
restart automatically.
Enter Y to confirm restarting the system.
Shutting Down the Remote System completed. Go to the next
section on your checklist.