To shut down NS, issue the following commands (NM capability required):
DSLINE @;CLOSENSCONTROL STOPNETCONTROL STOP
The DSLINE command shown above closes connections for your session only.
NSCONTROL STOP allows existing users to continue using the services
until they finish their current task but prevents new uses of the services by
these users or by new users. Therefore, the services are not actually stopped
until all existing users finish using them. You can use NSCONTROL ABORT
instead if you wish to immediately terminate all use of the services.
NETCONTROL STOP closes all open connections. To determine if there are
any sessions still active, enter: NSCONTROL STATUS. If you do not want
to wait until existing users are finished with their current tasks before you
bring down the system, issue NSCONTROL ABORT and then
NETCONTROL STOP.
If a host-based X.25 link is started, you will also need to issue a
DTCCNTRL command to stop X.25 and PAD support for the DTC/X.25 Network
Access card. Enter the DTCCNTRL command after the NSCONTROL STOP
and NETCONTROL STOP commands. Enter the command as:
DTCCNTRL DTC=dtcname;CARD=cardnumber;FUNC=function
where function is one of the following: