Cross-validation is automatically done on the KEEP, TAPE,
I/O, and RDCC commands in SYSGEN.
Cross-validation ensures that there are no conflicts in the use of node names,
device classes, and physical paths between the data currently contained in
NMCONFIG.PUB.SYS and the system configuration data.
To cross-validate, use the SYSGEN facility (OP capability is required). To use
SYSGEN, type the following commands at the MPE prompt:
:sysgen
sysgen> io
io> ld(optional)
io> exit
sysgen> exit
The optional ld (list devices) command allows you to verify the NMMGR
devices that are configured. For more information, see System Startup,
Configuration, and Shutdown.
If you have completed the configuration process, proceed to
Chapter 14 "Operating the Network"