You perform most of the daily operations required by the NS network through the
use of the provided NS 3000/iX network commands. Complete information on the
syntax and function of all the commands is contained in
Chapter 7 "Commands" of this manual.
The NETCONTROL START command allows you to initiate the network
transport as well as the individual networks on an active transport. The
NETCONTROL STOP command allows you to stop an individual NI or all
active entities of the network transport.
To start and stop the Network Services after the network is started, you use
the NSCONTROL START and NSCONTROL STOP commands. The
NSCONTROL ABORT command is useful when you need to terminate services
immediately.
See Chapter 2 "Operating Your Network" for step-by-step
instructions for using these commands.