Incomplete version information displayed when :NMMAINT,78
command is issued.
This indicates that the FOS software installation or update
(must be running on MPE/iX 7.0 or later) has not completed successfully.
Consult your HP software support representative.
Problem:
When an attempt is made to bring up the link (e.g., via a
:NETCONTROL START command for a LAN using that link), it does not
connect successfully. Connection failure messages are logged to the
console or a :LINKCONTROL linkname;STATUS=L command shows the link
as "DISCONNECTED".
This often suggests an incompatibility between the card's speed and duplex
settings and the switch or hub settings. Make sure to review the settings for
autonegotiation, speed and duplex in the link configuration data and make sure
they are consistent with what the hub or switch expects and supports. Bring the
LAN down (:NETCONTROL STOP or :DTCCNTRL option 4) and back up
again, to cause software to read the new configuration. If you still cannot
connect successfully, make sure all the cables are securely connected between
the card and the hub/switch and that the card is properly seated. If that
fails, consult your HP support representative.
Complete PDF