|
|
In addition to the normal command parsing errors and illegal command errors
from the utility SXOutil, the following new errors pertaining to the
creation and manipulation of the cluster block, are introduced:
MESSAGE: Cluster label exists already, cannot create another one |
Level:
CAUSE: This error is returned while executing the command
SXOMAKELABEL. This error indicates that an initial Cluster Ownership
ID block has already been created by invoking the command
SXOMAKELABEL.
ACTION: You only can reset this label to the current system by
invoking the command SXSETLABEL. If there is a need to re-create the
Cluster ID block, then issue the SXOREMOVELABEL command
first. |
MESSAGE: Volume mounted in invalid state for desired operation |
Level:
CAUSE: The command failed because the volume is mounted
in a wrong state.
ACTION: The volume should be in MASTER state in order to create
(SXOMAKELABEL) the Cluster Ownership ID block as well as to purge
(SXOREMOVELABEL) it. It should be in LONER state to reset
(SXOSETLABEL) to the current system. |
MESSAGE: Volume not a member of the set being initialized |
Level:
CAUSE: There is a mismatch between the setname and the ldev being
passed to the SXOMAKELABEL or SXOSETLABEL command.
ACTION: Cluster Ownership ID block can be created or reset
only on the master volume of a volume set. |
MESSAGE: Cluster ID is invalid for system volume set |
Level:
CAUSE: Cluster Ownership ID block is valid only for user
volume sets. |
MESSAGE: Cannot RESET because no Cluster label is found |
Level:
CAUSE: Cluster ID block needed to be created before it
can be reset to the current system.
ACTION: Issue the command SXMAKELABEL before issuing
SXOSETLABEL command. |
MESSAGE: Cannot purge. Cluster label not initialized |
Level:
CAUSE: Just a warning to indicate that the volume set is not
switchable. Issue SXOMAKELABEL command to create the Cluster ID
block before accessing the block using other commands. |
MESSAGE: Insufficient capabilities to execute this command. |
Level:
CAUSE: User does not have proper capability to execute this
command.
ACTION: User requires either CV or SM capability to execute
Cluster/iX commands. |
|