|
|
NM and CM callable.
Sets bits in the system job control word (JCW).
Syntax
U16V
SETJCW (jcword);
Parameters
- jcword
16-bit unsigned integer by value (required)
The user-defined bit contents of the system JCW for interprocess
communication.
- Bits
Value/Meaning
- 0:1
Reserved for the operating system
If (0:1)=1, the system outputs the following message when the program
terminates, either normally or due to an error:
PROGRAM TERMINATED IN ERROR STATE (CIERR 976)
In batch mode, the job is terminated unless the CONTINUE
command is used. If JCW is set to exactly %140000 (bits (0:1)=1 and
(1:1)=1 only), the CIERR 976 message is replaced by:
PROGRAM ABORTED PER USER REQUEST (CIERR 989)
- 1:15
Used for any purpose.
Related Information
- Intrinsics
FINDJCW, GETJCW, PUTJCW
- Commands
SETJCW, SHOWJCW
- Manuals
Interprocess Communication Programmer's Guide
Command Interpreter Access and Variables Programmer's Guide
MPE/iX Commands Reference Manual.
|