Install your system
software on new hardware and apply
PowerPatch patches
WARNING! Performing the activities in this task DESTROYS ALL
FILES THAT EXIST on your system. Do not perform a new installation
on an existing system.
NOTE:
Perform a new installation when new hardware has been shipped to
you and the operating system software is not already installed. This
is performed only once in the lifetime of a computer. Your system
software is shipped to you on tape media.
You cannot apply Reactive patches at the same time you are updating
the system. You must apply Reactive patches after you install the
system. To apply Reactive patches (after you install the system),
refer to Checklist A, "Manage Patches," or Checklist B, "Manage
Patches by Staging Area."
Print a copy of this checklist for each new system that you are installing.
Begin Preparation Tasks.Does not require exclusive access to
the system.
Read and perform the steps only in the following sections:
5.7 Creating the CSLT using AUTOINST —
Select option 3 FOS, SUBSYS, PowerPatch if you have a
PowerPatch tape, or if no PowerPatch, select option 4 FOS and
SUBSYS.
5.13 Applying the CSLT Modification
5.14 Restarting the System
5.15 Rerunning AUTOINST — Required only
if applying PowerPatch.