To list your system hardware

Before you start your system, you may want to use the MAPPER utility. Once initiated, MAPPER displays a user interface that gives you information about your disk drives, memory, processors and co-processors and allows you to modify any information that you need to change. To run MAPPER from the ISL prompt:

Type the following at the ISL prompt to get an ODE prompt:
ISL> ODE
Type the following at the ODE prompt to get a MAPPER prompt:
ODE> MAPPER

At the MAPPER prompt type:

   MAPPER> RUN

To exit MAPPER after you modify or accept the information displayed, you must exit out of MAPPER and ODE to get back to the ISL prompt. For example:

   1.  MAPPER> EXIT



   2.  ODE> EXIT



   3.  ISL>

NOTE: To use MAPPER after you have started up your system, you must first stop all system activity and shut the system down, for example, at the system console prompt:

   : [ [CTRL]] A

   =SHUTDOWN

Once the system issues the final shutdown message, transfer control by entering:

    [ [CTRL]] B

If this reply does not work, initiate a hard reset by entering:

   CM> RS

Then, at the ISL prompt, proceed as above (Step 1) to run MAPPER.

To list your system hardware

Technical documentation

» Table of Contents

» Index