 |
» |
|
|
|
The STREAMS command enables or disables the streams device, which
permits or prohibits you from streaming jobs. The system administrator
enters this command and STARTSPOOL LP after starting up the system to enable
the STREAM command. Syntax | |
Parameters | |
- ldev
Specifies the logical device number of the streams device.
The streams device must have an output device number or class that references
logical devices of type 32. You can use any input device except the
console or terminals. The input device must be configured in the
SYSGEN dialog as capable of accepting jobs.
- OFF
Disables the streams facility.
Operation Notes | |
Usage You can enter this command from a session, a job, a program, or in
break mode. Pressing Break does not affect this command. You can
enter this command only from the console; however, you can enter this command from your terminal if your system administrator has used the ALLOW command to enable
you to enter the command. Requirements The system administrator must enable the streams device every time that the
system is restarted in order to enable you to stream jobs. If you attempt
to stream a job when the streams facility is disabled, the following message
appears:
STREAM FACILITY NOT ENABLED: SEE OPERATOR. (CIERR 82)
|
Selecting the streams device The streams device is normally LDEV 10. Your system
administrator knows the LDEV for the streams device.
Examples | |
To enable jobs and data streams on logical device number 10, enter: To disable data streams, enter:
Related Commands | |
|
