HPlogo Commands Reference HP 3000 Series 9X8LX Computer Systems > Chapter 2 MPE/iX Commands

RESUMEJOB
» 

Technical documentation

Complete book in PDF
» Feedback

 » Table of Contents

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

The RESUMEJOB command resumes the processing of a job previously suspended with the BREAKJOB command. The job continues executing from the point where it was suspended. A message does not appear when processing resumes.

Syntax



   RESUMEJOB #Jnnn

Parameters

#Jnnn

Specifies a job number.

Operation Notes

  • Usage

    You can enter this command from a session, a job, a program, or in break mode. Pressing Break does not affect this command.

    You must enter this command from the console. You can only enter this command from a terminal other than the console under one of the following conditions:

    • The JOBSECURITY command is set to LOW and #Jnnn refers to a job logged on to your user.account (or @.account if you are the account manager).

    • Your system administrator has used the ALLOW command which permits you to enter this command.

Examples

  • To display suspended jobs and resume processing a job, do the following:

    1. Enter the following command:

         :SHOWJOB SUSP

      The system responds by displaying the following message:

         JOBNUM  STATE  INPRI  JIN  JLIST  INTRODUCED   JOB NAME

   #68     SUSP          105    LP   WED. 7:56AM  TEST,USER.ACCT

    2. Enter the following command to resume processing job number 68:

         :RESUMEJOB #J68

Related Commands



   ABORTJOB

   ALLOW

   BREAKJOB

   JOBSECURITY

   SHOWJOB


RESUME
  		 


RUN  
Feedback to webmaster